WATER HEATER & HOT WATER TANK INSTALLATION IN HAMILTON

Licensed and insured plumbers installing and replacing gas and electric water heaters across Hamilton, Ancaster, Dundas, Stoney Creek, Binbrook, Burlington, Grimsby, and Caledonia. Same-day changeouts when possible, safe gas and venting upgrades, haul-away of the old tank, and a written installed scope with clear pricing.

Call us todayRequest an Installation Quote
Water Heater Installation - Greg's Plumbing & Heating - Commercial Plumbing, Residential Plumbing, Plumbing Repairs
  • Same-day service
  • Licensed & insured
  • 280+ local reviews

Water Heater Installation & Replacement Services

Pick the issue below—no hot water, rusty tank, noisy heater, or a full upgrade to high-efficiency—and go straight to the fix.

OLD TANK REPLACEMENT

Swap out leaking, noisy, or end-of-life hot water tanks with new, code-compliant units. We match the size to your home, handle shutoffs and drain-down, and haul away the old heater.

NEW HOT WATER TANK INSTALLATION

Install a new gas or electric hot water tank in a finished or unfinished space. We set the tank, connect water and gas or power, set the temperature, and test for safe operation.

TANKLESS WATER HEATER INSTALLATION

Upgrade to tankless for endless hot water and better efficiency. We size the unit to your home, upgrade gas and venting if needed, and walk you through maintenance and filter care.

VENTING & GAS LINE UPGRADES

Bring older installations up to current code with proper venting, gas line sizing, drip legs, and shutoff valves. We correct unsafe piping, back-drafting, and shared vents.

MIXING VALVES & EXPANSION TANKS

Add or replace mixing valves, expansion tanks, and safety valves so you get steady, safe water temperatures and protect your plumbing from pressure swings.

UTILITY ROOM FLOOD & SAFETY UPGRADES

Add drain pans, leak alarms, shutoff valves, and proper floor drains to reduce damage if a tank fails. We can also relocate heaters off finished floors where practical.

From renting to owning

Water heater rental buyout
in Hamilton

Still paying monthly for your hot water tank? Before you buy it out, compare keeping your current heater with installing a new one you own. Greg’s Plumbing & Heating can assess your tank and quote a replacement, so you can weigh both options.

Keep your current tank

Buy out the existing rental

You pay your rental provider’s buyout amount and keep the heater already in your home. Consider its condition, remaining warranty and future repair costs before deciding.

The buyout buys your existing tank — not a new one.

Upgrade to a tank you own

Replace your rental water heater

If your tank is ageing, unreliable or no longer meets your needs, we can quote a new, properly sized heater. Include any rental exit costs when comparing the total.

Your rental agreement still needs to be settled.

How to get started

  1. Get your provider’s figures

    Ask for your written buyout amount, any other exit fees, and the return requirements that apply to your agreement.

  2. Get a replacement quote

    We assess the size, connections and venting, then explain the installation price and warranty coverage before you approve.

  3. Plan the changeover

    Confirm the rental exit arrangements before installation. Agree who will handle removal and any required return of the old tank.

Before removing a rental: confirm the process with your provider. Removing or replacing the tank does not automatically cancel the agreement or stop billing.

Considering a tank you own?

Get a clear replacement quote from your local Hamilton plumbing team.

Get My Replacement Quote Or call 905-928-6831
How much does an Enercare or Reliance water heater buyout cost?

There is no single price. Ask your provider for the amount that applies to your specific tank and agreement. Greg’s quotes the replacement installation separately, so you can compare the full cost before committing.

Will owning my water heater cost less than renting?

It depends on your monthly rent, buyout or exit charges, installation cost and future repairs. Owning removes the rental charge once the agreement is properly closed, but maintenance and repairs outside warranty become your responsibility.

Quick Checks Before You Call

NO HOT WATER

CONFIRM POWER, GAS & CONTROLS

For electric tanks, check that the breaker is on and the disconnect has not been bumped. For gas, confirm the gas valve is open and the thermostat is set above “vacation”. If you smell gas, leave immediately and call Enbridge Gas or 911 from a safe location.

NOT ENOUGH HOT WATER

CHECK TEMPERATURE & RECOVERY DEMAND

Make sure the thermostat is not set too low and that high-demand appliances (showers, laundry, dishwasher) are not all running at once. If you used to have plenty of hot water and now you do not, the elements, burner, or tank capacity may be failing.

RUSTY OR DISCOLOURED WATER

RUN A SHORT FLUSH & CHECK OTHER TAPS

Run the hot side in a sink or tub for a minute. If only the hot is rusty or dirty and the cold is clear, the tank is likely rusting inside. This is often a sign the heater is near the end of its life.

WATER ON THE FLOOR

CHECK FOR ACTIVE LEAKS & SHUT OFF IF NEEDED

Dry the area and see if new water appears from the tank, valves, or piping. If water is actively leaking or you hear hissing, close the cold-water supply valve above the heater and call us. Do not ignore steady drips or a “sweating” tank.

SMELL OF GAS OR BURNING

SMELL GAS? LEAVE IMMEDIATELY

Leave the building without using switches, phones or flames. Once safely outside, call Enbridge Gas at 1-866-763-5427 or 911. Do not re-enter until emergency responders say it is safe.

STRANGE NOISES

LISTEN FOR POPPING, BANGING OR WHISTLING

Popping or rumbling often means heavy scale inside the tank. Whistling can mean a failing relief valve. If noises are new, loud, or getting worse, shut off power or gas and book a visit so we can check for damage.

REPAIR VS. REPLACE: WHAT MAKES SENSE FOR YOUR HAMILTON WATER HEATER?

water heater repair

WHEN A REPAIR MAKES SENSE

Most water heater problems can be solved with a targeted repair when the tank itself is still in decent shape. A repair is worth considering if:

  • The heater is under 8–10 years old and sized properly for the home
  • You have no hot water from a failed element, thermostat, igniter, or pilot assembly
  • There are minor drips from valves or fittings, not from the tank body
  • You notice intermittent error codes, short-cycling, or nuisance pilot outages
  • Sediment or scale is present but the tank is not leaking and can be flushed
  • The unit is otherwise safe and you simply need a control, valve, or small part

When replacement is smarter

Replacement is usually the safer and more cost-effective choice when

  • The tank is older than 10–12 years or past the manufacturer’s typical lifespan
  • There is rust, bulging, or seepage from the tank shell or around the bottom seam
  • You are seeing discoloured or rusty hot water throughout the home
  • You want to switch to high-efficiency or tankless for better comfort and lower bills
  • The installation is not to current code for venting, gas piping, or relief valves
  • Repair costs are a large percentage of a new, warrantied heater
water on floor next to water heater

Why Hamilton Homeowners Choose Greg’s

  • Same-day service across Hamilton & area
  • Licensed & insured in Ontario
  • Thorough diagnostics with clear options
  • Hundreds of local 5-star reviews
Read our reviews
Company Van - Greg's Plumbing & Heating - Commercial Plumbing, Residential Plumbing, Plumbing Repairs

What to Expect

1

Arrival window & text updates

We confirm a short arrival window and text you when we are on the way. Same-day visits are available across Hamilton and nearby towns for most changeouts.

2

Floor protection & safe set-up

Shoes covered, mats down, tidy work area. We isolate water and power before we start.

3

Diagnose the real cause

We check the age, size, venting, gas or electrical supply, and recovery needs in your home so the new heater is properly sized and installed to current code.

4

Clear pricing before work

You get a written installed scope & range up front. No hourly surprises, just options that fit your home and budget.

5

Professional installation & tank removal

We remove the old heater, install your new tank, and complete the connections safely. Same-day replacement when available. Rental returns require prior arrangements.

6

VERIFY HOT WATER & CLEAN UP

We purge air, set the temperature, check for leaks, and test hot water at a few fixtures. Then we wipe down the area and review simple owner checks and maintenance.

7

Permits & code compliance

If your installation needs new venting, gas re-routing, or City paperwork, we advise you and handle the steps so the work and final inspection are up to code.

FAQ — WATER HEATER & HOT WATER TANK INSTALLATION IN HAMILTON

Most standard tank water heaters last 8–12 years in our area, depending on water quality, maintenance, and usage. If your tank is over 10 years old or showing rust or leaks, it is usually smarter to plan a replacement before it fails.

If the heater is under about 8–10 years old and the tank is not leaking, a repair for elements, thermostats, igniters, or valves can make sense. If the tank is older, rusty, leaking, or constantly running out of hot water, replacement is usually more cost-effective and safer.

Sizing depends on how many people live in the home, how many bathrooms you have, and when you typically use hot water. A typical Hamilton family home uses a 40–50 gallon tank, but homes with larger families, jetted tubs, or high-demand fixtures may need more. We size the heater during the visit so it matches your real usage.

A standard tank stores hot water and keeps it hot all day, which is simple and reliable but uses more standby energy. A tankless heater makes hot water on demand, saving energy and giving longer showers, but it needs proper gas sizing and venting. We can quote both options and explain which fits your home best.

Most straightforward like-for-like tank replacements take about 2–4 hours once we are set up. Tankless installations or jobs needing new venting, gas upgrades, or relocation can take longer. We give you a realistic timeline before we start.

In many cases, gas and venting changes require permits and inspections. We handle the paperwork, schedule inspections where required, and make sure your installation meets local code and manufacturer requirements.

In most cases, yes. If we have the correct size and type of heater available, we can often replace failed tanks the same day, especially for emergency no-hot-water calls. If a special-order unit or major re-piping is needed, we schedule the soonest available slot.

Keep stored hot water at 60°C (140°F) to help prevent harmful bacteria. A mixing valve reduces the temperature delivered to taps to 49°C (120°F) to help prevent scalding. We can check your settings and mixing valve.

Hamilton Homeowner Resources

water heater error

Water Heater Repair or Replace Calculator

Answer a few quick questions. Get a clear next step and book a licensed local pro. Works for tanks and tankless.

Use Free Tool
Homeowner on the phone making emergency plumbing calli while water leaks under kitchen sink into a bucket.

Water Heater: Repair or Replace?

Clear signs, cost cues, and when a new tank beats another repair.

Read
Greg's Plumbing & Heating blog post cover: Homeowner's Guide to High Water Bills. The graphic shows a faucet with water turning into bills.

High Water Bill? Silent leak checklist

Quick tests to catch running toilets and hidden leaks in minutes.

Read
2 pipes with shuoff valves and 2 signs saying main shuttoff valve

How to shut off your main water valve in Hamilton

Find the valve fast and stop water damage before it spreads.

Read